Technical Information; Installation Considerations - Hansgrohe Axor Bouroullec 19670401 Instructions De Montage / Mode D'emploi / Garantie

Tools Required / Outiles Utiles /
Herramientas Útiles
¼" / 6 mm
⅜" / 10 mm
2
English

Technical Information

Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - showerhead
Flow rate - handshower
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

Installation Considerations

• For best results, Hansgrohe recommends that this
• Please read over these instructions thoroughly
• The installer should be sure that the mounting loca-
• The included mounting hardware is suitable for solid
• Do not use the showerpipe as a grab bar.
• The shower arm is intended to support
• To prevent scald injury, the maximum output
10 mm
6 mm
5 mm
• Keep this booklet and the receipt (or other proof
10 mm
13 mm
17 mm
24 mm
unit be installed by a licensed, professional plumber.
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
tion for this product is flat (no projecting joints or
tiles) and that the wall is suitable for the installation
of this product.
surface walls, such as concrete, concrete wallboard,
dense natural stone, brick, gypsum wallboard/
plaster fiberboard surfaced with tile, marble, or
stone. Hansgrohe is not responsible for the cost of
alternate mounting hardware.
only the showerhead. Do not use the
shower arm to support other items.
temperature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum output
temperature can be no higher than 112° F.
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
15 - 75 psi
145 psi
120° - 140° F*
176°F*
2.5 gpm
2.5 gpm