fig. 1
X
HV-098133
EN
!!!Checking the spare tire!!!
I.
If there is the combination of alloy wheels on the
vehicle with a steel spare tire, an extra meas-
urement should be carried out .
II.
Fit the spare wheel without the spacer on the
side where the smallest distance is measured
(see point 11).
III.
Lower the vehicle and check the distance again
between dust cover D and the tire.
IV.
Distance > 4mm: spare wheel spacer does not
apply.
V.
Distance < 4mm: requires spare wheel spacer.
VI.
Install, if necessary, the correct wheel spacer
and double check the distance between dust
cover D and the tire.
VII. In the case of Point IV, the original bolts must
be kept with the spare tire when, by the combi-
nation alloy wheels and wheel spacers, other
wheel bolts are used.
VIII. In the case of point V or VI: and / or the wheel
spacer and / or the longer wheel bolts should be
kept near the spare tire if they depart from the
installation of the alloy rims.
11