mad MAX COMFORT Guide D'installation page 10

fig. 2a fig. 2b
fig. 3a
fig. 5a
fig. 4a
1
2
3 5
4
fig. 2c
fig. 3b
fig. 5b
HV-098133
EN
1. Raise the vehicle from the springs (front) and re-
move both front wheels.
2. Remove the shock absorber according to work-
shop manual.
3. Remove the central nut with ring, top bracket,
dust cover and steel ring. Dust cover (5) is no
longer used. (See Figure 2a, 2b and 2c).
4. Remove the three tabs from the steel ring (4).
Make sure that, after removal of the tabs, the ring
is completely flat (see Figure 3a and 3b).
5. Place spring cup B over the damper tube until it
rests on the mounting bracket of the damper.
Please note the recess (see Figure 5a).
6. Place auxiliary spring C over the damper tube
together with the upper spring disk A with inte-
grated needle bearing.
7. Then place the modified steel ring (4) and the
supplied dust cover D.
8. Mount the original top bracket (3), ring (2) and
central nut (1).
9. Install the shock absorber according to workshop
manual.
10. Install the front wheels and lower the vehicle.
11. Check the distance between the tire and the dust
cover D. Distance > 4mm.
12. Align the front of the vehicle and if necessary ad-
just height of the headlights.
10