Harness Assembly; Operating Instructions; Assembly Instructions - CLOROX Total 360 ProPack Manuel De L'utilisateur

Harness Assembly

1
2
3
4
5
1 Upper Harness
2 Upper Attachment
Bolt
3 Wand Attachment
Clip
4 Sternum
Strap/Buckle
Waist
5
Strap/Buckle
6 Shoulder
Straps
7 Tensioning
Straps
Lower Attachment
8
Bolts (2)
9 Lower Back Plate
8 | EN
Breathable padded back support for
ventilation and comfort.
Secures upper harness to backpack
unit. Can be adjusted to fit the
operator.
Clip for temporary spray wand
storage.
Strap to ensure even weight
distribution.
Strap to ensure even weight
distribution.
Breathable padded mesh shoulder
straps.
Used to lengthen or shorten the
backpack shoulder straps.
Secures lower back plate to
backpack.
Breathable padded lower back
support for ventilation and comfort.

OPERATING INSTRUCTIONS

Assembly Instructions

The backpack harness should be attached to the device prior to use.
To adjust the backpack upper harness:
1. Adjust the upper harness by loosening the tensioning straps.
Then using a Phillips screwdriver, thread the screw into one
of the three adjustable upper harness locations. The upper
pad should be secured once the screw is firmly tightened into
position.
6
7
8
9
Note: The upper part of the harness should sit between the
shoulder blades for proper fit. Taller users may need to move
the position up. Shorter users may need to move the position
down. DO NOT use any additionally assembly compounds
such as Loctite™ or grease.
2. To attach the lower part of the harness, use a Philips
screwdriver to thread the lower attachment bolts into the lower
back plate.
NOTE: DO NOT use any additional assembly compounds such
as Loctite™ or grease.