Troubleshooting; Equipment Warranty - CLOROX Total 360 ProPack Manuel De L'utilisateur

TROUBLESHOOTING

NOTE: Do NOT use a chemical in the unit that is not a Clorox-
approved product. If you encounter the issues listed below, use the
suggested troubleshooting methods. If you encounter an issue that
is not addressed in this manual, contact Service Tech Team at
www.servicetechteam.com.
System will not turn on or has shut off suddenly
Potential Cause
No Power
System is not switched on
Blower has overheated
No spray, erratic spray, or weak spray
Potential Cause
Out of liquid solution
Weak or erratic power
supplied to system.
Damage to loom assembly
Airflow seems low or weak
Potential Cause
Kink in loom assembly
Blockage in nozzle
Clogged air filter
Corrective Action
Verify the unit is plugged into
a known working outlet. Verify
that the system is in use with an
operational extension cord which
meets the specifications set forth
in the user manual. Inspect the
extension cord for damage. If the
unit still refuses to start, the user
should contact Service Tech Team.
Press main power button on back
of wand. Main power button will
illuminate.
Allow the unit to sit for a minimum
of 30 minutes with the power off.
Corrective Action
Inspect product container for
solution level and replace if empty.
Power the unit off, unplug from
the wall and plug into a different
electrical outlet. If another outlet
is not available, look to see if other
devices are running on the same
electrical circuit. Power those off
if necessary. This could also be the
result of an underrated extension
cord. See the EXTENSION CORD
section for additional details.
Inspect loom assembly for
escaping air or fluid. If found,
contact Service Tech Team for
replacement.
Corrective Action
Check to ensure loom assembly
is not pinched, kinked or bent too
tightly.
Power down and unplug backpack.
Visually inspect nozzle from
outside for blockages. Note:
Spray wand assembly, including
the nozzle is non-serviceable.
If there are problems with
obstructions in the wand or nozzle
assembly, please contact Service
Tech Team.
Replace air filter.
See MAINTENANCE section to
access and replace filter.

EQUIPMENT WARRANTY

THE CLOROX® TOTAL 360® PROPACK ELECTROSTATIC SPRAYER
COMES WITH A ONE YEAR WARRANTY. PLEASE REFER TO
THE MANUFACTURER'S WARRANTY POLICY FOUND AT
SERVICETECHTEAM.COM.
EN | 11