Maintenance; Air Filter; Spray Wand Assembly; Backpack Assembly - CLOROX Total 360 ProPack Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE

In order for the Clorox® Total 360® ProPack Electrostatic Sprayer
to remain functional, the equipment should be cleaned on a regular
basis. In addition to general cleaning of the unit, one user serviceable
area — the air filter — must be maintained and serviced regularly.
NOTE: As the sprayer becomes dirty from typical use, a 70%
isopropyl alcohol cleaner that is manually applied is recommended
on outside surfaces.

Air Filter

Looking at the bottom of the backpack, locate the Replaceable
Filter access panel (see SYSTEM COMPONENTS — BACKPACK
ASSEMBLY). Open panel and remove filter from slot. Replace with
OEM filter media, PN 600254. This filter must be replaced every three
months or 300 operating hours. Operating hours are recorded on
the on the Hour Meter (See SYSTEM COMPONENTS — BACKPACK
ASSEMBLY). To purchase spare parts, visit
www.servicetechteam.com.
NOTE: One filter is included in the device with three additional
filters for replacement.

Spray Wand Assembly

The spray wand assembly IS NOT field serviceable. Any attempt
to disassemble the wand or to perform field service will void the
warranty and likely damage the sprayer. Do not open the unit shell, as
doing so will void the warranty on the sprayer. If you are experiencing
issues with your spray wand assembly, please contact Customer
Support at www.servicetechteam.com. To clean the spray wand
assembly of excess debris, manually apply 70% isopropyl alcohol to
the exterior of the wand assembly using a cloth.

Backpack Assembly

The backpack assembly has no serviceable parts inside. Do not open
the housing, as doing so will void the warranty on the sprayer. If you
are experiencing issues with your backpack assembly, please contact
Customer Support at www.servicetechteam.com. To clean the
backpack of excess debris, manually apply 70% isopropyl alcohol
to the exterior of the backpack using a cloth.
10 |
EN
SPECIFICATIONS for 115V Model
Volts
~115V
Running Amps
4.2A
Frequency
60Hz
Hose Length
5 ft. (1.52 m)
Dimensions
Backpack: 21.2 in x 12 in x 6.5 in
(53.8 cm x 30.5 cm x 16.5 cm)
Weight – Empty
12 lbs (5.4 kg)
Weight - Full
21 lbs (9.5 kg)
Shipping Weight
23 lbs (10.4 kg)
Flow Rate
110-130 mL/min

Publicité

Table des Matières
loading

Table des Matières