INFOSEC UPS SYSTEM G1 Solar MPPT Manuel Utilisateur page 19

Maximum charging current:
To configure total charging
current for solar and utility
chargers.
02
(Max. charging current =
utility charging current +
solar charging current)
03 AC input voltage range
Power saving mode
04
enable/disable
05 Battery type
Auto restart when overload
06
occurs
Auto restart when over
07
temperature occurs
08 Output voltage
18
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 08 17 AA 59 201 05
10A 20A
30A 40A
50A 60A (default)
70A 80A
90A 100A
110A 120A
130A 140A
Appliances (default) If selected, the transfer time is within
20ms between battery mode and line
mode
UPS If selected, the transfer time is within
10ms between battery mode and line
mode
Saving mode If disabled, no matter connected load
disable (default) is low or high, the on/off status of
inverter output will not be effected.
Saving mode enable If enabled, the output of inverter will
be off when connected load is pretty
low or not detected.
AGM (default) Flooded
If "User-Defined" is selected, battery
User-Defined
charge voltage and low DC cut-off
voltage can be set up in program 26,
27 and 29.
Restart disable Restart enable
(default)
Restart disable Restart enable
(default)
220V 230V (default)
240V