Setting The Miter Angle; Clamping The Workpiece; Sawing - HOLZMANN MASCHINEN MKS 355 Mode D'emploi

13.1.3

Setting the miter angle


To do this, use an Allen wrench

Unscrew the two screws on the cheek and turn it to the de-
sired angle. You can read on the scale.

Tighten the screws again.
13.1.4

Clamping the workpiece


Place the workpiece before the jaw.

Place the fixing lever to the position as in the picture on the
right.

This allows you to move the jaw by pushing against the work-
piece.

Now put the fixing lever as shown in the picture on the right in
the position.

Turn the crank.

Thereby the workpiece between the jaws is clamped.
13.1.5

Sawing

Press the ON switch. The circular saw blade starts.

Wait until the circular saw blade to full speed is.

Press the blade down to the material and cut at a uniform rate.

Pull the blade upwards and release the ON switch.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
ON switch
25
MKS 355