Vetus BC12051 Manuel D'utilisation Et Instructions D'installation page 11

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
When the charger is being used, it will show LED lights as follows:
Green and red LED
light both off:
Green light flash-
ing only:
Green light on &
red light flashing:
Red light on only:
Green light & red
light both on :
Green light on
only :
vetus® Battery charger BC12051
NO AC Power
There is no AC power applied.
Standby for
The clamps are not properly connected to the bat-
charging bat-
tery.
teries
The battery voltage is below 1 volt.
The battery is fully discharged.
Charging battery
The charger is charging the battery.
Defective battery
Please make sure again the battery posts and clamps
or deeply dis-
are all clean.
charged battery
If the red light continues:
• Check if the battery is 12V battery or not.
• If yes, the battery does not hold a charge. It
• Or it needs more time to charge deeply dis-
If the red light still lightens after 20 hours charging,
please replace the battery.
75% Charged
The battery is at least 75% charged and is ready to
load test or can be returned to serve. Continued
charging will get the battery to be fully charged.
Some batteries will pass and accept a charge, but will
not be able to pass a load test. All batteries should be
load tested after charging.
Battery is fully
It will automatically adjust the voltage/current
charged and is
relationship to maintain the battery at a full charge.
under maintain-
The battery is ready for a load test or return to serve.
ing
If the battery voltage drops below 12.8 volts, the
charger shifts automatically into charging mode and
recharges to an OCV of 14.8 volt.
should be replaced immediately.
charged battery.
ENGLISH
11
090140.01

Publicité

Table des Matières
loading

Table des Matières