Switching Mirror Heating On/Off; Changing The Battery; Activating / Deactivating Measuring Mode - Villeroy & Boch Emotion Control Mode D'emploi

3.4 Switching mirror heating ON/OFF

4
• Press the button to switch on the mirror heater.
• Another press of the key switches the mirror heater off again.
> If it is not switched off manually, the mirror heater switches itself off after 30 minutes.
• Only in combination with a Heating Control: Hold the
activate / deactivate the functions of the Heating Control.
> Activating: The mirror heater status LED flashes 4x quickly.
> Deactivating: The mirror heater status LED flashes 4x slowly.

3.5 Changing the battery

1. Release the two screws on the back of the housing.
2. Open the cover and replace the battery.
3. Close the cover again. Make sure that the seal is located flush with the edge of the housing.
4. Fix the cover again using the two screws.

3.6 Activating / deactivating measuring mode

In measuring mode, 21 lighting scenes are run through in sequence. The change between scenes occurs in
soft transitions.
• Activating measuring mode: Hold the
> The lighting group flashes 3x quickly.
• Increasing the speed: Briefly press the
Reducing the speed: Briefly press the
• Deactivating measuring mode: Hold the
> The lighting group flashes 3x slowly.
• During measuring mode, the key commands for general operation are inactive.
www.villeroy-boch.com // V 1.0 // 21.02.2017 // Emotion Control DE/EN/FR/NL/RU DE/EN/FR/NL/RU
4
key down for at least 5 seconds to
key and 1 key down for at least 3 seconds.
key.
key.
2
key and key down for at least 3 seconds.
Battery
(CR 2032 3V)
13