Changing The Radio Channel Of The Emotion Control - Villeroy & Boch Emotion Control Mode D'emploi

2.1 Changing the radio channel of the Emotion Control

• An Emotion Control and receiver that have not been set to the same radio channel cannot
communicate with each other!
At the factory, all Emotion Control are set to radio channel 1. If you want to change the radio channel or pair
a second Emotion Control with the radio channel, proceed as follows:
1. Hold the and buttons down.
> The signal LED on the Emotion Control starts to flash.
2. Wait until the flashing stops and then release both buttons.
> The signal LED now starts to flash slowly for 5 seconds.
3. Within these 5 seconds, briefly press the
> Then comes the radio channel selection step: The signal LED flashes once for radio channel 1, twice for
radio channel 2, and so on. This sequence of flashing is repeated three times.
[.....]
1
2
[.....]
3
4
[.....]
4. Confirm the required radio channel by pressing the
> The Emotion Control confirms the change of radio channel by flashing quickly four times.
www.villeroy-boch.com // V 1.0 // 21.02.2017 // Emotion Control DE/EN/FR/NL/RU DE/EN/FR/NL/RU
key.
Radio channel 1
Radio channel 2
Radio channel 3
Radio channel 4
button during the pause after the signal flash.
3 x
11