Changing The Radio Channel Of The Receiver; Operation; Switching Lights On/Off; Adjusting The Brightness - Villeroy & Boch Emotion Control Mode D'emploi

2.2 Changing the radio channel of the receiver

• All receivers that are not to have their radio channels changed should be disconnected
from the power supply.
• The receiver's radio channel is changed via the Emotion Control. The Emotion Control
being used automatically uses the same radio channel as the receiver.
1. Hold the and buttons down.
> The signal LED on the Emotion Control starts to flash.
2. Wait until the flashing stops and then release both buttons.
> The signal LED now starts to flash slowly for 5 seconds.
3. During these 5 seconds, press the
> Then comes the radio channel selection step: The signal LED flashes once for radio channel 1, twice for
radio channel 2, and so on. This sequence of flashing is repeated three times.
[.....]
1
2
[.....]
3
4
[.....]
4. Confirm the required radio channel by pressing the
> The Emotion Control confirms the change of radio channel by flashing quickly four times.

3 Operation

3.1 Switching lights ON/OFF

1 2
1. Press the , or
> A further key press switches the lighting group off again.
2. Press the key to switch on all lighting groups at once.
> Press the key to switch off all lighting groups at once.

3.2 Adjusting the brightness

1 2 3
• Press the , or

3.3 Adjusting the colour temperature

1. Hold the key down to adjust the colour temperature of all lights to the cold white range.
2. Hold the key down to adjust the colour temperature of all lights to the warm white range.
12
key and hold it down until the signal LED goes out again.
3
key to switch the lighting groups of one channel on.
key down to adjust the brightness of the lighting groups on one channel.
www.villeroy-boch.com // V 1.0 // 21.02.2017 // Emotion Control DE/EN/FR/NL/RU DE/EN/FR/NL/RU
Radio channel 1
Radio channel 2
Radio channel 3
Radio channel 4
button during the pause after the signal flash.
3 x