Declaration Of Conformity; Environmental Protection - Worx WX337 Notice Originale

Selecting The Operating Mode
For simultaneous drilling and impacting
of concrete or masonry, choose the
Hammer drilling position.
For screw driving, drilling into steel,
wood and plastics choose the Rotary
drilling position.
For impacting only - for light chipping,
chiseling and demolition applications
choose the Hammer position.
WARNING: The operating
mode selector switch may be
actuated only at a standstill.
WARNING: Prolonged use
will cause the aluminum
housing to become hot, do not
touch.
WORKING HINTS FOR YOUR
DRILL(HAMMER)
If your power tool becomes over heated, set the
speed to maximum and run no load for 2-3 minutes
to cool the motor. SDS-plus tungsten carbide drill bits
should always be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good
condition. Always use a magnetic bit holder when
using short screwdriver bits. Where possible use a
pilot hole before drilling a large diameter hole.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep all
working controls free of dust.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling advice.
Rotary hammer
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product,
See Fig. G
Description Electric hammer
Type WX337 WX339 WX339.2
WX339.3(330~359--designation of machinery,
representative of Hammer)
Function
Complies with the following Directives,
2006/42/EC
2011/65/EU
2014/30/EU
Standards conform to
EN 60745-1
EN 60745-2-6
EN 55014-1
EN 55014-2
EN 61000-3-2
EN 61000-3-3
The person authorized to compile the technical file,
Name
Address
Grüner Weg 10, 50825 Cologne, Germany
2017/12/25
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P . R. China
Hammering various materials
Marcel Filz
Positec Germany GmbH
9
EN