Installing The Handles - Extel WECA 109059 Guide D'installation Et D'utilisation

VERY IMPORTANT:
All "rectangular" recesses have to be turned outward from the casing (fi g.4c)
Once this operation is fi nished, replace the plate ensuring the good position of all springs. Check the good operation
(keyboard, lock, latch...) before installing the assembly on the door.
REMINDER:
ALWAYS START BY PRESSING "C" BUTTON BEFORE ENTERING THE CODE,
then no order in the numbering is requested.
Once the modifi cations made, write down the new code.
Customised code:
4. INSTALLATION OF THE FLUSH-MOUNTED LOCK
See the manufacturer instructions for installing the fl ush-mounted lock.

5. INSTALLING THE HANDLES

1 - Verify the dimension of the "square" of your lock: It is of 7mm or 8mm.
For a 7mm square: you have to use the "k" adapter (fi g.1)
For a 8 mm square: you have to use the "j" adapters (fi g.1)
2 - Place the template (central pages of the note) and drill the 2 holes for assembling the 2 parts (keypad bloc and handle
block).
3 - Place the 2 parts front to front assembling them with the "d1" long guide and put the 2 blocks against the door. If the
guide used is too long, repeat the operation with the "d2" or the "d3 or the "d4" guide, if necessary.
4 - Final assembly (fi g.5)
At this step of the assembly we determined the proper adapters and the proper guide.
IMPORTANT
The adapters shall be positioned with the letters "L" and "R" in a legible position (fi g.5a)
1. Place the "j" or "k" adapters
2. Engage the "d1", "d2", "d3" or "d4" guide letting it stick out at each side of the door.
3. Engage the "m" springs, their conical part, on the side of the lock.
4. Place the embellishment front panels of the "C" cylinder.
5. Engage the "a" and "b" blocks in the guide and mount the assembly with the supplied screws
6. Test the keypad before closing the door.
FREE PASSAGE
You will fi nd on the internal block, a latch behind the handle to block the latch bolt in "permanent opening" position (hold
the handle down and move the latcht 2 fi g 6).
FREE PASSAGE FROM OUTSIDE:
For a permanent opening, just enter the code and then press 'Y' before turning the handle.
The Keyboard automatically switches to 'free passage'. Press 'Y' to return to a coded aperture.
GB
C
CFI EXTEL - WECA 109059 SER.R1 - 10-2015