Troubleshooting; Storage, Transportation And Operation Terms - Agu Octopy FP7 Mode D'emploi

11

TROUBLESHOOTING

Description
Steamer mode does
not start
Sterilization mode does
not start
Keep warm mode does
not start
Blender mode does
not start
Sterilization mode does
not start
Keep warm mode does
not start
Steamer mode does
not start
STORAGE, TRANSPORTATION
12
AND OPERATION TERMS
• The device should be transported at –10 °C to +40 °C with a maximum
relative humidity of 75 % or less.
• The device can be operated at temperatures from +10 °C to +40 °C with a
maximum relative humidity of not more than 65 %.
• Store the device at a temperature of +10 °C to +30 °C with a maximum
relative humidity of not more than 65 %.
• Do not subject the Unit to sudden temperature fluctuations.
ATTENTION
After transport or storage at low temperatures, it is necessary to keep the
device at room temperature for at least 2 hours before switching on.
82
Possible reasons
There is lack of water in
the water container
The blender bowl is
installed incorrectly
The bowl cover is
installed incorrectly
Solutions
Fill the container with water
Install the blender bowl
to the main unit and turn
counterclockwise until it stops.
The opening of the blender bowl
and the steam outlet have to be
aligned
Install the bowl cover on the
blender bowl again and turn it
counterclockwise so that the
cover locks into place