Publicité
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum
Flow rate (max.)
handshower
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water
heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
Four-hole models only:
• The four-hole trim sets require rough 06646000
(not included).
• Protection against backflow is provided by a
check valve in the handshower elbow and by an
automatically resetting diverter.
• This unit is not anti-scald. In Massachusetts, or
if required by local plumbing code, install an
approved remote pressure balance valve or
other approved anti-scald device.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
158°F (70° C)*
1.75 GPM (6.6 L/min)
• The three-hole trim sets require rough 06607000
(not included).
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F (49°C). In Massachusetts,
the maximum output temperature can be no
higher than 112°F (44°C).
• The handshower is for use with automatic
compensating valves rated at 1.3 GPM (4.9 L/min)
or less.
Publicité
