Swinging The Brush; Adjustment Of Handle; Technical Specifications; Troubleshooting - Texas Handy Sweep 600 Manuel D'utilisation

Swinging the brush

The brush can be pivoted 20 degrees to either side. This is done by pushing the swing
handle down, turning the brush and releases the handle so the detent clicks into place.
The swing handle is shown on Figure 2, item k.

Adjustment of handle

Adjust the handle such that the working height is comfortable. Use the hand wheels on
each side of the handle bar.
Figure 2, e.

Technical specifications

Model
Total width (mm)
Working width (mm)
Weight w/o fuel (kg)
Brush diameter (mm)
Swinging brush (positions)
Speed (km/h)
Tire size
Tire pressure (psi)

Troubleshooting

Problem
The engine won't start:
1. Check sparkplug.
2. Check that the spark plug cap is fitted correctly.
3. Check if the motor is equipped with an ignition switch.
(It must be activated)
4. Check if the motor is equipped with a fuel valve.
(It must be activated)
The engine runs unevenly:
1. Check that the choke has been released.
2. Check fuel for impurities.
If the brush will not run:
1. Check that the clutch is adjusted correctly.
2. Check that the belt is tight.
If the machine will not run:
1. Check that the clutch is adjusted correctly.
2. Check the belt.
If the machine does not sweep effectively:
1. Check the distance between the brush and working surface.
Solution
14
Handy Sweep 600
650
600
66
350
3
3
3.00 x 10
30