Vess A2200 Guide De Démarrage Rapide page 28

PROMISE Technology
Step 2: Remove housing cover
Figure 30: Remove housing cover
1. Use a small Phillips head screwdriver to remove all five screws that secure the cover to the rest
of the device housing. There are two small flat head machine screws, one on each side, and
three dome head machine screws that secure the cover to the backplate.
2. Slide the cover toward the rear of the device until it can be lifted off.
Step 3: Insert PCIe card
Removal of the cover exposes the PCIe slots located in the rear left corner.
1. Pull out the protective cover for the PCIe opening for the slot that will be used. Save this
protective cover for future use.
2. Insert the PCIe card so that it is firmly seated in the PCIe slot. When prop-erly seated, the
bracket will flush with the backplate of the device allowing access to the PCIe functional
connection. It is not necessary to anchor the bracket with a screw since the housing cover will
hold the card securely in place when the device is completely reassembled.
Figure 31: Remove PCIe cover and insert card
Step 4: Replace housing cover
Now simply replace the hosing cover on the device. Place the cover into the accom-modating guides on each
side of the housing and push the cover back into place. Secure the cover with the five screws (one flat head
screw on each side, the three re-maining on the back), do not over tighten the screws.
26