Vess A2200 Guide De Démarrage Rapide page 12

PROMISE Technology
Figure 11: Drive slot numbering for Vess A2200s/A2200
Install all of the drive carriers into the enclosure to ensure proper airflow, even if you do not populate all the
carriers with disk drives.
Installing Your Disk Drives
The instructions below apply to all types of drive carriers intended for use with the Vess A2200 or Vess
A2200s.
1. Remove a disk drive carrier.
2. Carefully lay the disk drive into the drive carrier at the front, so that the screw holes on the sides
line up.
3. Insert the screws through the holes in the drive carrier and into the sides of the disk drive.
Install only the counter-sink screws supplied with the drive.

Install four screws per drive.

Snug each screw. Be careful not to over-tighten.
4. Reinstall the drive carrier into the enclosure.
Repeat steps 1 through 3 until all of your disk drives are installed.
Figure 12: Disk carrier with HDD installed - front view
Push here when returning
or replacing the carrier into
an empty drive bay.
Tabs for locking mechanism insert. This piece must be
removed to unlatch the carrier. To remove, squeeze the
tabs together and pull out. To reinsert, squeeze the tabs
together and replace in position. Do not discard the
locking mechanisms.
Drive numbers
(odd)
The Vess A2200/A2200s supports disk drive hot-swapping. To avoid hand contact
with an electrical hazard, do not remove more than one drive carrier at a time.
Drive numbers
(even)
Cautions
Pull here to release the carrier handle latch.
Then pull the carrier straight out by the handle.
Do not drop the disk carrier, even if it is empty.
10
Place your free hand under the carrier.