Satelec Acteon Air-Max Notice D'utilisation page 8

5. Maintenance
Cleaning and disinfecting the device
The casing of the Air Max as well as the cords should be
cleaned and disinfected every day, using alcohol or
disinfectant dental wipes.
Cleaning the polishing system
It is imperative that the powder circuit is purged before any
cleaning takes place.
The powder drum
Carefully empty the drum of powder if the device is not to be
used for several hours (overnight for example). Residual
dampness of the air alters the powder's properties.
To clean the powder drum, unscrew the reservoir cap and
remove the residue using the dental chair's suction system.
The ProphyPen handpiece
After each use, unscrew the ProphyPen handpiece nozzle
(ref .20) and clean in an ultrasound tank for 10 minutes
(fragments the powder), dry well and sterilize the nozzle and
ProphyPen handpiece in an autoclave.
Cleaning the filters
The water filter
Cleaning the water filter must be done in relation to the
hardness index of the water. Proceed as follows:
1. Shut off the water at the tap on the water
supply side and purge the circuit.
2. Set the on/off button to the "O" position and
unplug the mains lead.
3. Unscrew the two parts of the filter (ref. 21 and
23) using two 10mm open-ended spanners.
4. Extract and replace the cartridge (ref. 22).
5. Reassemble by reversing the operation,
retightening the two parts of the filter (ref. 21
and 23).
6
The air filter
When water is present, purge by turning the black screw (ref.
13) clockwise.
To stop the purge, turn the screw in the opposite direction.
Replacing the fuses
Proceed as follows:
1. Set the on/off button to the "O" (ref. 24)
position and unplug the mains lead (ref. 25).
2. Insert the end of a screwdriver (ref. 26) in the
slot to open the protective cover.
3. Replace the fuses (ref. 27) by fuses of the same
type and value.
4. Push the fuse holder back into its housing.