Operation And Maintenance; Tips And Recommendations For Use - Simu Autosun 2 Notice Originale

9 CANCELLING PROGRAMMING
During the operations in this section (§9), do not work on several motors at the same time.
9.1-
9.1- Disconnect the solar panel from the T3.5 EHz DC motor
9.2 - Disconnect the battery from the T3.5 EHz DC motor for 2 seconds.
9.3 - Connect the battery to the motor for 7 seconds.
9.4 - Disconnect the battery from the motor for 2 seconds.
9.5 - Restore the power supply. If the motor is on the end limit position (up or down), the motor will run briefly in
one direction and then in the other, otherwise, the motor runs for 5 seconds in random direction.
The motor is now in the « cancelling mode".
9.6 - Then, confirm the cancelling of the concerned
motor from the individual control:
- Press the PROG key of the transmitter more than
7 seconds. Maintain the pressure until the motor will
first run for 0,5 second in one direction and then in the
other, and a few second later, it will run again in both
direction.
i
The memory of the motor is now completely deleted. You can connect the solar panel onto the battery, and
then proceed to the complete programming (§2).
i
It is possible to perform the double power-cut procedure directly from the solar panel's connector
(without disconnecting the battery from the motor), if the following two conditions are met:
-The motor radio must be in standby mode (see § 4).
- The solar panel must be illuminated by diffuse sunlight, flashlight, ...for less than 10 min. If it is illuminated
for more than 10 minutes, disconnect the solar panel for 10 seconds.
- Then follow double power-cut procedure 9.2, 9.3, 9.4, 9.5, from the solar panel connector (the connection
between battery and the motor is kept), before carrying out operation 9.6.
10

OPERATION AND MAINTENANCE

- This drive is maintenance-free.
- Press the ▲ button on the control point to raise the motorised product.
- Press the ▼ button on the control point to lower the motorised product.
- If the motorised product is moving, briefly press the "Stop" button, the motorised product stop automatically.
- The motorised product is then stopped, briefly press the "Stop" button, the motorised product moves to the
programmed intermediate position. (To modify or delete an intermediate position, see the section §7).

Tips and recommendations for use:

Problems
The motorised product is not operational.
The motorised product stops briefly before rising
when the Up button is pressed.
The programming of the motor is not possible.
If the motorised product still does not work, contact a drive and home automation professional.
SIMU SAS, F-70103 GRAY as manufacturer hereby declares that the drive covered by these instructions and used as intended according to these instructions
is in compliance with the essential requirements of the applicable European Directives and in particular of the Machinery Directive 2006/42/EC, and the Radio
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at www.simu.com. Emmanuel CARMIER, general director, GRAY, 10/2017.
EN
8/8
9.2- 9.3-
2s
Causes possibles
The battery of the control point is
low.
The battery of the system is low
The battery of the system is low
The battery of the system is low
9.4-
2s
7s
9.6-
1
PROG > 7 s
2 s
9.5-
>>>>
7s
>>
7 s
Solutions
Check the battery and
replace is as required.
Recharge the battery
Recharge the battery
Recharge the battery
5 s