Tips And Recommendations For Use; Possible Causes - Simu T5 AUTO SHORT Hz Notice Originale

Modification of the rotation direction (in user mode):
8
Do not move the roller shutter to the up or down end limit position.
1 - Press the "Up" and "Down" buttons simultaneously for 5 seconds. The motor
runs briefly in one direction, then in the other.
2 - Within 2 seconds, press the Stop button for 2 seconds. The motor briefly runs
in one direction, then in the other. The rotation direction has been changed.
After stage 1, if no operation is carried out before 2 seconds, the motor runs again briefly in one direction
and then in the other, and the rotation direction is not changed.
Cancelling programming & settings
9
9.1- Switch off the power supply to the motor for 2 seconds.
9.2- Switch the power to the motor back on for 7 seconds.
9.3- Switch off the power supply to the motor for 2 seconds.
9.4- Switch the power to the motor back on.
If the motor is on the end limit position (up or down), the motor will
run briefly in one direction and then in the other, otherwise, the
motor runs for 5 seconds in random direction.
The motor is now in the «cancelling mode».
If you switch off the power to several motors, they will all be in cancelling mode. That is why, you must «eject» out of
this mode all the receivers that are not to be deprogrammed by sending a command from their individual control trans-
mitter (UP or Down).
9.5- Then, confirm the cancelling of the concerned motor from the individual control:
- Press the PROG key of the transmitter more than 7 seconds. Maintain the
pressure until the motor will first run for 0,5 second in one direction and then
in the other, and a few second later, it will run again in both direction.
i
The motor is now as it was originally configured, and no transmitter and no
settings is saved in its memory and is ready for a new programming.
Operation and maintenance
10
- This drive is maintenance-free.
- Press the ▲ button on the control point to raise the motorised product.
- Press the ▼ button on the control point to lower the motorised product.
- If the motorised product is moving: briefly press the "Stop" button, the motorised product stops automatically.
- The motorised product is then stopped, press 0,5s on the "Stop" button. The motorised product moves to the
programmed intermediate position. (To modify or delete an intermediate position, see the section §7).

Tips and recommendations for use:

PROBLEMS
The motorised product does not operate. The overheating protection on the drive has been activated.
If the motorised product still does not work, contact a drive and home automation professional.
Simu SAS, F-70103 as manufacturer hereby declares that the drive covered by these instructions when marked for input voltage 230V~50Hz and used
as intended according to these instructions, is in compliance with the essential requirements of the applicable European Directives and in particular of
the Machinery Directive 2006/42/EC, and the Radio Directive 2014/53/EU. The full text of the EU declaration of conformity is available at www.simu.com.
Emmanuel CARMIER, general director, GRAY, 11/2016.
OFF
9.1 2s 9.2

POSSIBLE CAUSES

1
5s
2s
ON OFF ON
7s 9.3 2s 9.4
PROG >7s
2s
7s
SOLUTIONS
Wait for the drive to cool down.
2
2s
5s
4 / 4