Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Contents
Connecting the Units ................................ 1
Power cable connection .................................... 3
Connecting to separately sold power amp ........ 5
processor .................................................... 7
connection box .......................................... 8
outputs ........................................................ 9
component ................................................ 10
Installation ................................................ 11
DIN Front/Rear-mount .................................... 11
DIN Front-mount ............................................ 11
DIN Rear-mount .............................................. 12
1
Connecting the Units
WARNING
• To avoid the risk of accident and the potential vio-
lation of applicable laws, the front DVD or TV
(sold separately) feature should never be used
while the vehicle is being driven. Also, Rear
Displays should not be in a location where it is a
visible distraction to the driver.
• In some countries or states the viewing of images
on a display inside a vehicle even by persons other
than the driver may be illegal. Where such regula-
tions apply, they must be obeyed and this unit's
DVD features should not be used.
CAUTION
• PIONEER does not recommend that you install or
service your display yourself. Installing or servic-
ing the product may expose you to risk of electric
shock or other hazards. Refer all installation and
servicing of your display to authorized Pioneer
service personnel.
• Secure all wiring with cable clamps or adhesive
tape. Do not allow any bare wiring to remain
exposed.
• Do not drill a hole into the engine compartment to
connect the yellow lead of the unit to the vehicle
battery. Engine vibration may eventually cause the
insulation to fail at the point where the wire passes
from the passenger compartment into the engine
compartment. Take extra care in securing the wire
at this point.
• It is extremely dangerous to allow the display lead
to become wound around the steering column or
gearshift. Be sure to install the display in such a
way that it will not obstruct driving.
• Make sure that wires will not interfere with mov-
ing parts of the vehicle, such as the gearshift,
parking brake or seat sliding mechanism.
• Do not shorten any leads. If you do, the protection
circuit may fail to work properly.
Publicité
Chapitres
Table des Matières
