Before Use; Safety Instructions - JB Systems Light Led Snow Flakes Mode D'emploi

ENGLISH
OPERATION MANUAL
®
Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own
safety, please read these operating instructions very carefully before you start using this unit.
FEATURES
This unit is radio-interference suppressed. This product meets the requirements of the current European and
national guidelines. Conformity has been established and the relevant statements and documents have been
deposited by the manufacturer.
 This device was designed to produce decorative effect lighting and is used in light show systems.
 This very attractive 360° LED effect simulates snowflakes falling at irregular intervals.
 This wonderful plug & play decoration effect is a perfect eye catcher for Christmas time!
 One set contains:
 2,5m wire with 5 icicles installed at 50cm intervals
 Length of each icicle = 50cm
 Each icicle contains 64 bright white LEDs (total = 320 LEDs).
 low voltage adapter 230V/12Vac adapter.
 Very low power consumption of only 1,2 Watt, thanks to WHITE LED technology
 Thanks to special fixing points, the effect can be easily attached to any surface

BEFORE USE

 Before you start using this unit, please check if there's no transportation damage. Should there be any, do
not use the device and consult your dealer first.
 Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary
for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused
by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects
or problems caused by disregarding this user manual.
 Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user
manual.
Check the contents:
Check that the carton contains the following items:
 Operating instructions
 2,5m wire with 5 icicles.
 230Vac/12Vac adapter

SAFETY INSTRUCTIONS:

CAUTION
The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the
use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may
be of sufficient magnitude to constitute a risk of electric shock.
The exclamation point within the equilateral triangle is intended to alert the user to the presence
of important operation and maintenance (servicing) instructions in the literature accompanying
this appliance.
This symbol means: indoor use only
This symbol means: Read instructions
This symbol means: Safety Class II appliance
JB SYSTEMS
®
OPERATION MANUAL
CAUTION: To reduce the risk of electric shock, do not
remove the top cover. No user-serviceable parts inside.
Refer servicing to qualified service personnel only.
1/20 LED SNOW FLAKES
ENGLISH
The device is suitable for mounting on standard flammable surfaces. Standard flammable
surfaces include building materials such as wood and wood-based materials more than 2mm
thick.
 To protect the environment, please try to recycle the packing material as much as possible.
 To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
 This unit is for indoor use only.
 Don't place metal objects or spill liquid inside the unit. Electric shock or malfunction may result. If a foreign
object enters the unit, immediately disconnect the mains power.
 Prevent use in dusty environments and clean the unit regularly.
 Keep the unit away from children.
 Inexperienced persons should not operate this device.
 Maximum save ambient temperature is 40°C. Don't use this unit at higher ambient temperatures.
 Always unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing.
 Check that the available voltage is not higher than the one stated on the rear panel of the unit.
 The power cord should always be in perfect condition. Switch the unit immediately off when the power cord
is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
 Never let the power-cord come into contact with other cables!
 In order to avoid a hazard, the unit shall only be used with the AC-adaptor delivered with it. If the AC-
adaptor is damaged, a same model adaptor shall be used only.
 Don't connect the unit to any dimmer pack.
 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
 The housing and the lenses must be replaced if they are visibly damaged.
 Please use the original packing when the device is to be transported.
 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important: Don't use the effect in the presence of persons suffering from epilepsy.
DESCRIPTION:
1. AC-ADAPTER: 230Vac/12Vac adapter, simply connect this to the mains.
2. AC-CONNECTOR: special IP44 connector, connect the wire of with icicles here. Make sure that the
clamping ring of the connector is well tightened before you start using the effect.
3. ICICLES: 5 icicles, each containing 64 white LEDs. You can fix the top of the icicle easily with a nylon
strap or clamp to any surface.
4. T-PIECE: contains a hole so you can fix it easily with a nylon strap or clamp to any surface.
5. END CONNECTOR: could be used to extend the wire, this option is not provided. Please make sure that
the connector is well tightened and sealed.
OPERATING INSTRUCTIONS
 Once connected to the mains the device starts running.
 Do not switch the unit on and off in short time intervals as this reduces the lamp life.
 Always unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing.
 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
JB SYSTEMS
®
OPERATION MANUAL
2/20 LED SNOW FLAKES