Fakir BT 200 Mode D'emploi page 18

A
B
C
D
Before refolding the ironing board pull the plug of the power cord out of the socket. Then
remove the steam cord. Be careful when touching the hot parts ! Use the iron protec-
tion shell when the iron is hot.
Wind the power cord around the cord-winder D. Turn the ironing board sideways with the
tank at the bottom. Push the height adjustment lever A and refold the legs. Push the legs
tightly against the ironing board until they are retained by the leg clip.
18
Preparing the ironing board
The ironing board can be put away with the legs folded
under the ironing surface or upright with the legs folded,
and the tank at the bottom. The ironing board stands by
itself in this position.
The ironing board can be opened from the upright positi-
on, too:
Hold the ironing board tight with one hand and open its
legs until you hear a click. This means that the lever is in
the locking position. The ironing board can now be easily
placed in the upright position ready for use.
If the floor is slippery be careful that the legs do not slide
when opening or closing the ironing board.
Press on the lever A and raise the ironing surface to the
desired height.
Place the iron on flat surface B of the tank near the safety
cap.
Place the hot iron on this surface only: its thermo-resistant
rubber studs make it heat-resistant.
Placing the hot iron on other surfaces could cause dama-
ges.
Insert the plug of the iron or of the steam jet into the socket
in the lower side of the tank C. Make sure that on inserting
the plug the safety flap of the socket snaps into place. This
stops the plug being pulled out of the socket unintentio-
nally. Plug the power cord into the wall socket only after fil-
ling the tank with water.