STEINEL IS 3180-24 Consignes D'installation page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8
Installation
Installation - ceiling mount
with threaded nipple
• Confirm power is off at the
circuit breaker
• Install power pack and
run low voltage wire to the
sensor location
• Run low voltage wires from
the sensor through the
provided threaded nipple and
snap threaded nipple in back
of sensor
Ceiling Tile
Ceiling Tile
www.steinel.net
(800) 852-4343
• Cut 7/8" hold in ceiling tile
• Place threaded nipple
through hole in ceiling tile,
add washer and secure with
locknut
• Wire sensor to STEINEL
power pack
Threaded Nipple
Threaded Nipple
Locknut
Locknut
Washer
Washer
Sensor
Sensor
Operation
The IS 3180-24, IS 3360-24 and
IS 345-24 work with a STEINEL
power pack to control lighting
based on occupancy and daylight.
Manual operation
A line voltage or low voltage
switch may be used for manual off
control when the power pack is in
automatic on mode.
For manual on only operation, a
low voltage momentary switch is
required along with a STEINEL
power pack set in manual on
mode.
Light level function
The sensors incorporate a built-in
light level sensor which keeps
lighting off during daylight hours,
regardless of occupancy.
www.steinel.net
(800) 852-4343
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Is 3360-24Is 345-24

Table des Matières