Inserting And Charging The Bat; Basic Operation; Charging - Bosch BBS61 Manuel D'utilisation

en Basic operation

Basic operation

Basic operation
You can find out everything you need
Basic operation
to know about operating your appli-
ance here.

Charging

Depending on the appliance features,
you can charge the battery in three
different ways.
WARNING
Risk of fire!
Improper use of the battery and the
1
rapid charger
Only charge the battery in char-
▶
gers that are recommended by the
manufacturer.
Only use the battery in connection
▶
with the Bosch appliance.
Charge the battery using the ori-
▶
ginal charging cable
ginal quick charger
Only use batteries from the Power
▶
for ALL 18 V series.
Charging using the charging cable
Note: The power supply unit on the
charging cable
heat up while charging. This is nor-
mal and harmless.
Requirement: The battery has been
inserted.
→ "Inserting and charging the bat-
tery", Page 33
Place the vacuum cleaner close to
1.
the socket.
Plug the appliance plug into the
2.
vacuum cleaner.
→ Fig.
6
1
Depending on the appliance specifications
34
is dangerous.
1
or the ori-
1
.
1
and the appliance
Insert the mains plug into the
3.
socket.
a The status display slowly flashes
white while the battery is charging.
Once the battery is fully charged,
the status display lights up white
for a few minutes.
Tip: To check that the battery has
charged fully, briefly disconnect the
vacuum cleaner from the mains. The
status display then lights up white.
You can charge the vacuum cleaner
whenever it is not in use.
Charging in the base station
WARNING
Risk of injury!
An appliance that falls may endanger
people.
Ensure that children do not play
▶
with the appliance, even when it is
in the base station
Note: The power supply unit on the
charging cable
heat up while charging. This is nor-
mal and harmless.
1
Requirement: The battery has been
inserted.
Insert the vacuum cleaner into the
▶
base station
→ Fig.
a The status display flashes white
while the battery is charging. Once
the battery is fully charged, the
status display lights up white for a
few minutes.
Tip: To check that the battery has
charged fully, briefly disconnect the
vacuum cleaner from the mains.
Once the status display lights up
white, the appliance is fully charged.
1
.
1
and the appliance
1
from the front.
7
1