Sony UPX-C300 Mode D'emploi page 63

Troubleshooting
Check the following items prior to submitting the
equipment for repair. If the problem persists, contact
your nearest Sony dealer.
Camera
Symptom
The camera does • The camera's internal processing is
not enter standby taking a long time.
mode even if the
tWait a while. If the power still does
on/standby switch
not enter standby mode, disconnect
is set to
the power cord or remove the
1 (standby).
batteries.
The on/standby • The power of the printer is not turned on.
switch of the
tTurn the printer on, and then turn the
camera is set to
camera on.
? (on), but the
• The Bluetooth module of the camera or
camera and printer
printer is turned off.
are not connected.
tTurn on both of the modules. (See
"Setting the Module Power" (on
page 55).)
• "NO PRINTER" appears.
tThe registration of the printer is
cancelled. Register the printer. (See
"Adding/Registering a Printer" (on
page 57).)
tThis is a problem with camera. Contact
The standby lamp
is lit orange or red, your nearest Sony dealer.
and the camera
does not operate.
While Taking Pictures
Symptom
A picture is not • The mode switch is not set to
taken when the
tSet the mode switch to
release button is
• Image data storage is in progress or the
pressed.
flash is charging (the standby lamp is
rapidly flashing orange).
tWait until the standby lamp lights
orange.
• The memory is full (the standby lamp is
flashing orange).
tCheck the indication for the
remaining number of pictures that can
be taken. If it is zero, erase any
pictures that are not needed.
tSet AUTO ERASE to ON.
Cause/Solution
Cause/Solution
.
.
Symptom
The flash does not • Flash Mode is not set appropriately.
fire.
tSet FLASH MODE in the menu to
, or
Mode" on page 33)
• The external flash is not lighting
properly.
tSet FLASH MODE in the menu to
, or
Mode" on page 33)
• The batteries are dead.
tConnect the camera to an AC power
source, or charge the batteries.
• The life of the flash is used up.
tContact your nearest Sony dealer.
Camera LCD
Symptom
If the camera is • This is a normal phenomenon associated
used in a cold with LCDs.
location, residual
tThis is not a malfunction.
images may
appear on the
LCD.
Black spots may
appear or red,
blue, green, or
other color spots
may remain on the
LCD.
A printer icon • The printer is printing a picture.
appears in the
tWait until printing finishes and
center of the LCD,
perform the operation again.
and the camera
does not operate.
The display image • Paper is being fed to the printer.
freezes for a while
tThe display image will change when
after data
the paper finishes feeding and printing
transmission ends.
begins.
Printing
Symptom
Pictures do not • The camera is set to Shooting mode.
print, even if the
tPictures can only be printed from
PRINT button is
auto-review display or Playback
pressed.
mode.
• The print queue function is enabled.
tPrint using the print queue function,
or cancel this function. (See "Using
the Print Queue Function" on page
36)
Cause/Solution
. (See "Selecting the Flash
. (See "Selecting the Flash
Cause/Solution
Cause/Solution
Troubleshooting
63