Safety Information; Notes; Installation; Environmental Conditions - Elbro SMSB12T Manuel De L'utilisateur

Safety Information

• The SMSB12T device incorporates a latest generation Dual-band GSM module. To install and use it correctly, the indications given in this manual
are to be strictly respected.
• The SMSB12T device is a low-power radio transceiving device. When it is operating, it sends and receives radio frequency energy. Operating the
SMSB12T device close to radios, televisions, telephones or electronic devices in general may cause interference. The SMSB12T device may be
subject to interference that affects its performance.
• Do not install the SMSB12T device close to pacemakers, auditory prostheses or medical devices in general as the SMSB12T device may interfere
with the operation of these devices.
• The SMSB12T device must be turned off on airplanes. Make sure that the device cannot be turned on accidentally.
• Do not use the SMSB12T device in the presence of inflammable gases or fumes. Turn off the device when close to petrol stations, fuel deposits and
chemical plants.
• The SMSB12T device operates by means of a radio signal, no mobile telephone operator is capable of ensuring a connection at all times. For this
reason, the SMSB12T device cannot be used in life support systems.

Notes

• All information contained in this manual is subject to change without prior notice.
• No part of this manual may be reproduced, in any form or by any means, electronic or physical, or otherwise, including photocopying or storage, for
needs other than the personal use of the user, without the prior written permission by Elbro AG.
• The use, copying, modification, disassembly or transmission of the software is forbidden.
• All other trademarks and products are referring to their respective owners.

Installation

In order to ensure the operator's safety and the correct operation of the SMSB12T device, the device should be installed exclusively by qualified staff.
The rules listed below should also be strictly ob-served.

Environmental conditions

The SMSB12T (the device and its wiring) should be installed in places which fit the following requirements:
• No dust, humidity or high temperatures
• No direct exposure to sunlight
• Keep away from objects radiating heat
• No objects generating a strong electromagnetic field
• No corrosive liquids or chemical substances
• The SMSB12T device has been designed to operate at a temperature of between -5°C and +45°C (standard working temperature)
• Avoid quick changes in temperature or humidity

Degree of Protection

Make sure to match the following protection degrees:
• IP40: minimum degree of protection, must be guaranteed at all times
• IP54: protection to be guaranteed when using the device outdoors

Power supply

Observe the following rules:
• Do not use cables longer than 2m
• The external power supply unit (e.g. mains charger), must comply with the EN 60950 Directive (electrical safety)
• Observe the correct polarity (+/-)
Digital Inputs
Observe the following rules:
• do not use cables longer than 2m
• do not install the cables in proximity of possible electromagnetic fields or use shielded cables

Relay Output

During the installation of the device, strictly observe the indications given in this manual.
Install the external equipment correctly and observe the technical data in this manual. Never exceed any of the values to be found in the technical data.
2