Unpacking - Aerial AD 110 Série Mode D'emploi

warehouses, and is designed to be wall
mounted.
The dehumidifier must only be mounted,
used and stored in rooms larger than
2
4 m .
The dehumidifier must only be used in
compliance with the Technical Data (see
last page).
Persons with physical, sensory or mental
restrictions and children
permitted to use the dehumidifier.
Every user must
understood the operating instructions.
Foreseeable misuse
The dehumidifier must not be used:
•
In rooms with potentially explosive
atmospheres.
•
In rooms with
atmosphere (e.g.
chemicals).
•
In rooms with water with a pH value
below 7.0 or above 7.4.
•
In rooms with salt or liquids with a
salt content > 1 %, e.g. brine baths.
•
In rooms with ozone-treated air,
high solvent concentrations or high
dust pollution.
General safety information
WARNING! Risk of explosion, burns
and poisoning from refrigerants!
The appliance contains an odourless,
flammable refrigerant which, if handled
incorrectly, could result in explosions
and fire as well as injuries and burns.
The refrigerant circuit is pressurised.

Do not use any objects to accelerate
the thawing process.

Do not store the dehumidifier in
rooms with permanent sources of
ignition, such as open flames,
operational gas
electric heaters.
are not
have read and
an aggressive
caused by
appliances or
16

Do not drill
dehumidifiers.

Only operate the appliance in an
adequately ventilated room larger
2
than 4 m .

Any work to the refrigerant circuit
must be performed
manufacturer or the manufacturer's
authorised technical
Before working on the refrigerant
circuit, it must be depressurised
using the designated mechanisms.

Observe the national regulations for
gas installations.

Do not dump refrigerants or dispose
of them as household waste.

Avoid coming into contact with the
refrigerant.
WARNING! Electrocution!
Working on live components or water on
live components
threatening electrocution.

Avoid contact between water and
live components.

Always switch off and unplug the
dehumidifier before moving it to
another location.

Only allow the manufacturer or
authorised personnel to carry out
work on electric components.
7

Unpacking

Procedure
1. Check that the package contents
are complete. Contact your stockist
in the event of damage or missing
contents.
2. Remove the packaging and
dispose of it in accordance with
local regulations.
open or ignite
by the
personnel.
can cause life-