Safety Instructions For Connecting The Device To The Mains; Safety Instructions For Operating The Device - Gloria MULTIJET Mode D'emploi

230v
Masquer les pouces Voir aussi pour MULTIJET:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
Protect the device against long expo-
sure to the sun and frost.
In order to prevent damage and
hazards resulting from improper
use , you must observe the user
manual and store it in a safe place!
Wear suitable work clothing such as
safety goggles, ear protection long
trousers and, if necessary, gloves
during cleaning. Do not work
barefoot or in light sandals.
If the device is passed on to other
persons, they must also be given the
user manual!
Only use GLORIA original spares and
accessories
for
Never use worn, modified or defec-
tive replacement parts / accessories!
2.2 Safety instructions for con-
necting the device to the mains
DANGER
DANGER OF ELECTRIC SHOCK!
Contact with energised cables/wires
or components may result in serious
injury or death! You should therefore
observe
the
following
instructions:
If the power cable is damaged,
it must only be replaced by a repair
shop designated by the manufactur-
er in order to prevent a hazard !
Please contact the manufacturer or
the customer service department.
Ensure that the supply voltage
corresponds with the voltage (V)
of the device !
Only connect the device to an AC
grounded power outlet.
The circuit breaker supplying mains
power to the high-pressure washer
should have no less than a C16 rating.
The device should be operated using
a residual-current-operated protec-
tive device (RCD) with a release cur-
rent
of
no
30 mA. Ask your elec trical installer!
When using an extension lead, only
use a grounded cable for outdoor
use with a conductor cross-section of
at
least
1,5
2,5 mm
2
/<50m!
the
device.
safety
more
than
mm
2
/<20m;
23
The mains plug and coupling of the
extension cable must be water tight
and may not be placed in water. The
coupling may not be on the floor.
Use cable drums to ensure that the
sockets are at least 60 mm above the
floor. All live parts in the work area
must be protected against water jets.
Do not run over, crush or pull the
power supply cord or extension cord,
otherwise it may be damaged. Pro-
tect the cable from heat, oil and
sharp edges.
The mains plug must be removed:
- In the event of faults during opera-
tion
- Prior to any cleaning
- After use
2.3 Safety instructions for
operating the device
ATTENTION
Improper use of the device poses a
risk of damage to property! You should
therefore observe the following safety
instructions:
Do not immerse the device in water
or spray or clean it with water.
The device must be protec ted
against moisture.
Never use the pressure washer with-
out the filter or with a dirty or dam-
aged filter.
DO NOT operate the device in dry
running for longer than 1 minute.
NEVER operate the device at tem-
peratures below 0° C.
Observe
the
following
precautions
to
prevent
and material damage due to misuse
and unsafe handling of the product.
Misuse can result in INJURIES.
WARNING
RISK OF INJURY DURING OPERATION!
Use the device as intended!
Do not use the device with wet hands.
safety
injuries

Publicité

Table des Matières
loading

Table des Matières