Milwaukee 0920-20 Manuel De L'utilisateur page 7

WARNING
mended for this tool. Others may be hazardous.
Attaching/Removing the Vacuum Cart
1. To attach, place rear of vacuum on the cart with
the front angled upwards. The vacuum inlet should
face the front of the cart where the pedal is located.
2. Slide the rear of the vacuum under the ledge feature.
3. Lower the front of the vacuum so it lines up with
the cart and front ledge. Once the cart clicks, the
vacuum is secured on the cart.
4. To remove, press one foot on the pedal. Lift the
vacuum with handle away from the cart.
Installing/Removing the Hose
To install the hose, line up notches on the hose
with the vacuum inlet. Push in and twist toward lock
to secure in place.
To remove the hose, twist the hose towards the un-
lock and pull away from vacuum inlet.
Only use accessories
specifically recom-
Ledge
Feature
Installing/Removing the Accessories
To install the nozzles, or extensions, push the ac-
cessory onto the vacuum hose until it clips in place.
To remove the accessory, open hose clip and pull
the accessory off the vacuum hose. Store the ac-
cessories in the motor head or in the designated
cart storage areas.
Installing/Removing the Dust Extraction
(Use Cat. No. 49-90-1980 for 0920-20 and
Cat. No. 49-90-2000 for 0930-20, not included)
The dust extractor hose adapter is used to connect
the hose to a power tool in place of other dust col-
lection, such as a dust bag.
To install the adapter, remove any nozzles or acces-
sories from the end of the hose. Twist the adapter
onto the hose until tight for a secure fit.
To remove, reverse the procedure.
Installing/Removing the Accessory
Storage Bag
(Cat. No. 49-90-2019, not included)
1. To install, ensure the top of the motor housing is clear.
2. Place the accessory storage bag on top of the
motor housing with the logo facing up.
3. Locate the hooks on the accessory storage bag
and attach them to the storage tie downs on the
motor housing. NOTE: There are 2 storage tie
downs on each side of motor housing with a total
of 4 storage tie downs.
4. To remove, unhook the accessory storage bag
from the motor housing and remove the acces-
sory storage bag.
7
Adapter