Milwaukee 0920-20 Manuel De L'utilisateur page 6

ASSEMBLY
WARNING
the battery packs before removing the tank.
CAUTION
dependent on the filter. A dirty filter will reduce
the air flow and overall efficiency of the system.
Remove from tank and tap clean.
WARNING
the battery. For specific charging instructions,
read the operator's manual supplied with your
charger and battery.
Removing/Inserting the Batteries
To remove the batteries, push in the release buttons
and pull the battery packs away from the tool.
WARNING
tool is not in use.
To insert the batteries, slide the pack into the body
of the tool. Make sure they latch securely into place.
NOTICE
The vacuum/motor head requires
two charged battery packs to oper-
ate.
• The vacuum/motor head will not work with only one
battery pack.
• If one battery pack is completely depleted the
vacuum/motor head will not function regardless if
the other battery pack has capacity remaining.
Removing/Installing the Filters
Use the high efficiency filter for dry pickup only. Use
the foam filter for wet pick-up operation only.
1. Remove the battery packs.
2. Release the tank latches and lift off the motor
housing. Place it upside down on a flat surface.
3. To remove the filter, turn it 1/2" counter clockwise
and pull it off of the motor housing/float cage.
4. Empty all debris from the tank.
NOTICE
jobsite guidelines pertaining to
the disposal of silica dust.
5. To install the filter, slide it over the float cage. Line
up the filter tabs with the motor housing notches
and turn it 1/2" clockwise to lock in place.
6. Replace the motor housing and secure both
latches.
To reduce the risk of
injury, always remove
Keep filter clean. Efficiency
of the vacuum is largely
Recharge only with the
charger specified for
Always remove the bat-
tery packs any time the
When applicable, adhere to
WARNING
glasses and a dust mask when using the vacuum
cleaner as a blower. Clean tank completely before
use.
Pick-Up/Blower
The vacuum can be used for debris pick-up or as a
blower, depending on the port used.
1. For the debris pick-up, insert the large end of the
hose into the intake port of the motor housing,
lining up the tabs on the hose with the notches in
the port. Twist to secure and form a tight fit.
2. To use as a blower, insert the large end of hose
into the blower port
up the tabs on the hose with the notches in the
port. Twist to secure and form a tight fit.
6
To reduce the risk of
injury: wear safety
of the motor housing, lining