Vido iV60x080 Manuel D'installation page 6

5.0 Controls
(continued...)
Installer's Set-up Parameters
To access the installation parameters menu, scroll to AUTO (while
in full mode), then press (OK) for 10s. Use (
keys to highlight the parameter to be adjusted. Press (OK) to toggle
the parameter setting, when the value starts to blink, use the (+)
Parameter
Name
dEG Select temperature scale.
00:00 Select the hour format.
AIr Calibration of the internal air sensor against the actual
(Air) room temperature.
(The calibration must be done after 12 hours working at
the same set temperature).
CSP
Cooling set point.
HSP Heating set point.
AiPu The air pulse will operate 5 minutes on the 5 minutes off
to ensure effective air circulation in cooling.
Nb vAL Selection of the number of valves to be driven.
(2 Pipe
This parameter depends on the system design.
models only)
FAS SPEE Allows the maximum fan speed to be switched off - the
unit will only run in Low and Medium speeds.
NIGt Select option for fan speeds when the unit reverts to
night set back in cooling operation.
CLr ALL Reverts the control back to factory settings.
End Exit the installation menu.
Program Mode
Built-in Program Selection
A quantity of 9 built-in (P1-P9) and 4 user defined (U1-U4) timed
program options are available to choose from. Each day is divided
into 24 one hour periods operating in either Comfort setting (21°C
default) or Night set-back setting (19°C default).
Built-in programs description
P1 Morning, Evening & Weekend
P2 Morning, Afternoon, Evening
& Weekend
P3 Day & Weekend
06
) and ( )
Description
P4 Evening & Weekend
P5 Morning, Evening
P6 Morning, Afternoon & Weekend
P7 7h-19h (Office)
and (-) keys to adjust the value. Then, press (OK) to confirm. Once
parameters are set, go to <End> parameter and press (OK) to go
back to the main menu.
Default Setting
°C
12H
To adjust the air sensor temperature, enter the
measured temperature using the (-) or (+) keys.
To confirm the calibration, press (ok)
Press (+) and (-) keys at the same time to reset
the offset value.
The default water switching temperature for cooling
is 15°C, this can be altered by pressing (+) or (-) keys
then pressing (ok) to confirm.
The default water switching temperature for heating is
32°C, this can be altered by pressing (+) or (-) keys then
pressing (ok) to confirm.
YE5
(Yes)
0 valve
FA5
For Fast
NOr
(For Normal regulation)
Press (OK) for 5 seconds
Scroll to the preferred program number P1-P9 (FIG 9, A) using the
(+) and (-) keys. The controls will then automatically go back to
AUTO mode.
P8 8h-19h, Saturday
P9 Weekend only
Alternative Setting
°F
24H
NO
(No)
1 valve
NEd
For Medium
AL1
(Fan speed 1 only)
Press (OK)
EN