Connections - Denon DRA-395 Mode D'emploi

ENGLISH

5 CONNECTIONS

• Do not plug in the power cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left
with left, right with right).
• Insert the plugs securely. Incomplete connections will result in
the generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not use
them for hair driers, etc.
Connecting the audio components
Turntable (MM cartridge)
NOTE:
This unit cannot be used
with MC cartridges
directly. Use a separate
head amplifier or step-
up transformer.
R
L
LINE IN
Tape deck
R L R L
R L R L
OUTPUT INPUT
Connecting a tape deck
Connections for recording:
Connect the tape deck's recording input jacks
(LINE IN or REC) to this unit's tape recording
(OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck's playback output jacks
(LINE OUT or PB) to this unit's tape playback
(IN) jacks using pin plug cords.
6
OUTPUT
R
R
Ground
wire
R L
PHONO
ZONE 2
MULTI
IN
ROOM
SIGNAL
ZONE 3
CD
GND
LOOP
OUT
AM
ANT.
L
DVD/
DVD/ VDP
VDP
R
IN
FM
COAX. V. AUX V. AUX
75
ANTENNA
L
TERMINALS
VCR VCR
PRE OUT
R
SUB CDR/
MONITOR
WOOFER
TAPE
OUT
ZONE
VCR VCR
2
L OUT
R
VIDEO
CDR/
ZONE
TAPE IN OUT
3
OUT
R L
MULTI ROOM AUDIO ROOM TO ROOM (REMOTE CONTROL)
L
R
R L
AC OUTLETS
• SWITCHED (total capacity – 120 W (1 A.)
The power to this outlet is turned on and off in conjunction with the POWER operation switch on the
main unit, and when the power is switched between on and standby from the remote control unit.
No power is supplied from these outlets when this unit's power is at standby. Never connect
equipment whose total capacity is above 120 W (1 A.)
NOTE:
Use the AC OUTLETS for audio equipment only. Do not use them for hair driers, etc.
• Note that binding pin plug cords together with power cords or
placing them near a power transformer will result in generating
hum or other noise.
• If hum or other noise is produced when the ground wire is
connected, disconnect it.
• Noise or humming may be generated if a connected
component is used independently without turning the power of
this unit on. If this happens, turn on the power of the this unit.
CD player
L
DIGITAL AUDIO DIGITAL AUDIO
L
SPEAKER SYSTEMS
B
R L
SPEAKER IMPEDANCE
A OR B / 4 16
A + B / 8 16
AUX OUT
Sub room (ZONE 2)
RC-617 (Sold Separately)
Infrared sensor
+
OUTPUT
Power amplifier
Power amplifier
Connecting the AC OUTLETS
Connecting a CD player
Connect the CD player's analog output jacks (ANALOG
OUTPUT) to this unit's CD jacks using pin plug cords.
AC CORD
AC 120 V, 60 Hz
AC OUTLETS
A AC 120V 60Hz
SWITCHED
R L
TOTAL 120W(1A.) MAX.
RC-616 (Sold Separately)
Infrared retransmitter
+
+
INPUT INPUT
Sub room (ZONE 3)
RC-617 (Sold Separately)
Infrared sensor
+
OUTPUT