Elica Stone Gallery Prescriptions De Montage Et Mode D'emploi page 15

the suction version. If you want to use the hood in the
filtering version, fix flues support bracket G to deflector F
and connect the other end of the tube to the connection
ring placed on deflector F.
15. Connect the electricity.
16. Apply the flues and fix the lower part with 4 screws.
17. Fix the upper flue to flues support bracket „G" with 2
screws.
Remount the carbon filter frame and the fat/s filter/s and check
the perfect functioning of the hood.
Additional instructions for the montage
Front panel characteristics.
Fig. 6
The front structure is preset for installing panels of various
materials.
The panels must have the following characteristics:
They must be made of self-tightening material, able to support
a maximum working temperature of 80°C.
They must have dimensions similar to the dimensions of the
metal support.
They must not weigh more than 10 Kg.
The panel manufacturer must create a fixing system
suitable for the type of material and the weight of the
panel, using the 4 passing holes present on the metal
support.
We decline any responsibility for possible damage to
things and/or people caused by improper use or failure to
observe the above instructions.
Description of the hood
Fig. 1
1. Control panel
2. Grease filter
3. Grease filter release handle
4. Halogen lamp
5. Vapour catcher
6. Telescopic chimney
7. Air outlet (used for filter version only)
8. Light point.
9. Front panel.
Operation
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
A.
B.
B+C. medium power selection aspiration
B+D. maximum power selection aspiration
15
on/off light switch.
on/off aspiration switch and minimum
power selection
switch
switch