VAPamore MR-500 VENTO Mode D'emploi Et Manuel De L'utilisateur page 8

USING YOUR MR-500 VENTO
GO TO VAPAMORE.COM TO SEE THE MR-500 VENTO INSTRUCTIONAL VIDEO
Fig. 12
Reset button
RESET
Fig. 13
Fig. 14
Carpet height indicator
HEIGHT
RESET
Fig. 15
petal
Fig. 16
ELECTRIC FLOOR HEAD
contact Vapamore service at 480-951-8900. Fig. 12
upright/stored and operating. When in the upright/stored
position the handle is locked into place. To lower the
handle to the operating position, push the handle release
pedal. Fig. 13
Handle
The carpet height adjuster has a range of 1-6 and is
release
adjusted in according to the surface being cleaned.
petal
Always adjust going up (1 up to 6) until you reach the
desired setting. When adjusting down (6 down to 1)
the adjuster is designed to skip numbers to return to
1 faster. Adjust by depressing the foot pedal located
Carpet
height
depending on the surface being cleaned. If cleaning rugs
adjuster
or carpet turn on the rotating brush. If cleaning hard
vacuum on. Fig. 15
Always check to make sure the rotating brush is clear and
free of any pet hair or debris. Remove and clean any built
up debris from the rotating brush. Also make sure the
Note: The rotating brush uses a special designed drive
Keep intake
belt. In the case that the drive belt should break due to
and brush
clear of
over stress or a brush jam, contact Vapamore for service at
debris
480-951-8900 or visit vapamore.com to order a
replacement drive belt.