Filter Bag - VAPamore MR-500 VENTO Mode D'emploi Et Manuel De L'utilisateur

USING YOUR MR-500 VENTO
GO TO VAPAMORE.COM TO SEE THE MR-500 VENTO INSTRUCTIONAL VIDEO
Fig. 6
Fig. 7
Min.
suction
Power
cord
re winder
2
Fig. 8

Filter bag

full indicator
1
Fig. 9
3
Fig. 10
Fig. 11]
OPERATION
Once you have assembled the vacuum, pull the power
On/Off
cord out and plug into a standard outlet. Never pull the
power cord past the marked stop point as this may
damage the auto re winder. Retract the power cord by
pressing the petal until the cord is fully rewound. Fig. 6-7
Power cord
re winder
Turn the vacuum on by pressing the on/off petal. To turn
the vacuum off press the petal again. Fig. 6-7
Once the vacuum is turned on you can adjust the variable
Max
suction settings by pushing the plus (+) or minus (-)
suction
buttons located on each side of the control panel. This
allows you to adjust for low suction for delicate surfaces
like drapery all the way to the maximum suction for deep
carpets. When vacuuming rugs use a setting 1 to 2 under
maximum as most rugs have rubber backing and will not
On/Off
allow the vacuum to breath properly. Using to high of a
setting on rubber backed or flow restricted areas can
damage the vacuum motor or drive belt. Fig. 7
FILTER BAG
The filter bag full indicator light will turn red when the filter
bag is full and needs replacing. There are three conditions
that will cause the indicator light to come on. 1,The filter
bag is full and needs to be replaced. 2, Very fine powder
has clogged the pores in the filter bag even if not
completely full it must be replaced. 3, There is a clog in
the nozzle, hose, tools, or at the filter bag opening that
must be cleared. Note: The filter bag full indicator is
designed to notify the user when the filter bag is full. If
the filter bag is full of pet hair, carpet fibers, or any loose
light fibers the bag full indicator may not light up due to
Filter bag
sufficient air flow in the filter bag. Discard the full filter bag
compartment
latch pull up
and replace with a new one. Fig. 8
The filter bag must be maintained to keep the vacuum
operating at maximum efficiency. Change the filter bag
frequently or when the filter bag full indicator comes on.
To replace the filter bag, first disconnect the vacuum hose
from the vacuum by depressing the two buttons on each
side of the hose connector. Then lift the filter bag
compartment latch and open the lid. Fig. 9
Before removing the filter bag pull on the tab "A" to seal
the filter bag and keep dust from escaping as the filter
bag is changed. Then pull the filter bag out and discard.
Fig. 10
Replace with a new filter bag by sliding the bag into
the bag retainer in the direction of the arrow located on
the filter bag. Once the filter bag is in place, close the lid.
Fig. 11