THOMSON TT200BT Manuel D'utilisation page 11

Note: the cartridge provided has a tracking force range of 4-6 grams according to the manufacturer. All
cartridges have their own tracking force; please refer to their respective specifications.
Before use, make sure to:
Remove the stylus protector.
-
Release the tonearm clamp and make sure the tonearm is free to move
-
from the tonearm rest. Lock the tonearm in place again when not in use.
1. Lift the turntable dust cover (1).
2. Place the record on the platter (use the 45 rpm record adapter to play 45 rpm records).
3. Set the speed selector (10) to the right position for the record you are playing.
4. Push the cueing lever (11) upwards.
5. Lift the tonearm from the tonearm rest and slowly move it over the record to
the desired position. The platter will start turning.
6. Push the cueing lever (11) down to slowly lower the tonearm onto the record
and start playback.
7. When the record is finished, the tonearm will automatically return to the
tonearm rest.
8. To stop manually, lift the tonearm from the record and return it to the rest.
Pausing the playback
Pushing the cueing lever (11) upwards will lift the tonearm and temporarily stop
Note:
- The turntable's mechanical auto-return system may enable during transportation. Thus, the tonearm
will automatically return to the rest the first time it is placed on the platter – this is not a malfunction.
- Since records vary in length, you may find the tonearm cannot automatically return to the rest once the
record has finished. In this case, please adjust the tonearm's stop position as indicated below.
- Do not use a magnetic cartridge or it will no longer be possible to connect the unit via the Aux-in on an
external device.
Adjusting the pitch
Use the pitch control knob (9) to adjust the turntable speed.
Tonearm stop position alignment
You can adjust when the tonearm returns to the tonearm rest once the record has finished as follows:
OPERATING THE TURNTABLE
3
playback.