Accessories - PerkinElmer OMNI Bead Ruptor 96 Manuel D'utilisation

Safety instructions when working
The Bead Ruptor
milling of milling jars. Milling jars can be pre-cooled in a liquid nitrogen bath then
placed on the Bead Ruptor
Cooling times and processing times will be dependent on target material. It is highly
recommended that you follow the safety instructions for handling liquid nitrogen
provided by your liquid nitrogen provider.
WARNING: Always wear protective gloves and googles when working with liquid
nitrogen. Liquid nitrogen has a temperature of -196°C and will cause severe burns
and frostbite with skin or eye contact.
Milling Jars
Stainless Steel 25 mL - set of two
Stainless Steel 50 mL - set of two
Grinding Balls
10 mm stainless - set of ten
25 mm stainless - set of five
Well Plate and Tube Adapters
Stainless Steel - set of two
PTFE - set of two. (Holds 48 x 0.5 - 2 mL
microcentrifuge or screw cap tubes)
96 Well 2D Barcode Storage Tube Adapters
Micronic/FluidX 1.1 and 1.4 mL
with septum style caps.
Thermo Fisher Scientific
Matrix 1.1 m L, Micronic 1.1 mL , 1.4 mL
and FluidX 1.1 and 1.4 mL storage tubes
with septum style caps.
2 mL Stainless Steel Tubes - set of two
tubes with slugs
with Liquid Nitrogen
96 Homogenizer can be operated with liquid nitrogen for cyrogenic
TM
96 Homogenizer for dissociation of tough materials.
TM

Accessories

Order Number
27-004
27-006
27-203
27-206
27-101
27-106
27-107
27-108
19-6001