LD Systems CURV 500 Série Manuel D'utilisation page 9

MONO / STEREO
26
To have a Mono summed output signal on the mixer, the MONO / STEREO (26) switch on the mixer control panel must be pressed down in the MONO
position. If the MONO / STEREO switch is not pressed down, the output signal is in stereo.
27 MAIN LED
If an audio signal is present on the sum channel, the LED lights up green. As soon as the LD CURV 500
the LED turns red. Brief flashing is not a cause for concern, since the internal audio limiter compensates for over-modulation. Permanent illumina-
tion should be avoided by reducing the input level.
MAIN LEVEL
28
Volume control for the summing channel. When turned to the left, overall volume levels are lowered, when turned to the right, they are raised.
29 SUB LEVEL
Adjusting the volume ratio of the subwoofer to the satellite speakers.
DSP PRESETS
30
Since it is possible to vary the number of connected LD CURV 500
homogeneous sound distribution for all four variations (equalizer settings and adjusting the bass level). Set the rotary encoder on number 1 if you
only want to operate one satellite in the LD CURV 500
you want to operate 2, 3, or 4 satellites in the system.
31 DFX PRESETS
16 different effects presets are available to you. Use the rotary encoder to select one of the presets as desired.
CONNECTIONS, CONTROLS AND INDICATORS
32
36
LDCURV500SE
The Subwoofer expansion LD CURV 500
the subwoofer expansion allows the connection of additional LD CURV 500
signal processor) integrated into the LD CURV 500
32 GROUND LIFT
This feature can prevent ground loops that can occur when the subwoofers LD CURV 500
potentials.
satellites (1 - 4 units), the DSP settings must be adjusted accordingly, to achieve a
®
system (1 unit for mono or 1 unit each left and right for stereo). Proceed in the same way, if
®
34
33
37 38
® SE, when used individually, complements the bass output of the LD CURV 500
S Subwoofer via the 5-pin XLR system cable, additional system settings are thus not required.
®
® array system is operated in the clipping range,
35
satellites. The intelligent signal control is carried out by the DSP (digital
®
® S and LD CURV 500 ®
® array system. Furthermore,
SE are connected to different earthing
9