LD Systems CURV 500 Série Manuel D'utilisation page 7

POWER LED
7
Lights up once the system is properly connected to the power mains and switched on.
8 POWER CONNECTOR WITH FUSE HOLDER
IEC power socket with built-in fuse holder. An appropriate power cord is included in the delivery. IMPORTANT INFORMATION: Replace the fuse only
with a fuse corresponding to the operating voltage. Please observe the label on the housing. If the fuse blows repeatedly, please contact an
authorised service centre.
9 POWER ON / OFF
On / Off switch for the power supply of the device.
SATELLITE OUT LEFT / RIGHT
10
Speakon compatible outputs for controlling the LD CURV 500
simultaneously (e.g. for voice and sound). When using a CURV 500
of the LD CURV 500 satellites and the MONO / STEREO (26) on the mixer control panel switch must be pressed down (MONO). When using a LD CURV
ES Entertainer Set as a Stereo Set (2 array satellites mounted left and right), or when using the LD CURV 500
500 ®
outputs LEFT and RIGHT to control the LD CURV 500
be pressed down (STEREO). An incoming stereo audio signal will be output in stereo. The use of the LD CURV 500
combination of LD CURV 500 ® ES and LD CURV 500
on the left. The LD CURV 500 ® satellite on the right is controlled by the satellite output of the expansion subwoofer SATELLITE OUT RIGHT.
11
12
13
14
15
LED CH 1
11
When a signal is present at the input of channel 1 (CH 1), the LED indicator lights up green; if the LED is red, the channel is operating at the clipping
range. To avoid distortion, reduce the volume level of the volume controller (12) of channel 1.
LEVEL CH 1
12
Volume controller for channel 1 (CH 1). Turning the dial to the right increases the volume and turning it to the left decreases it.
EQUALIZER HIGH CH 1
13
Equalizer high band for channel 1 (CH 1). When turned to the left, levels are lowered, when turned to the right, they are raised. In the centre position
(resting point), the equalizer is inactive.
® satellites. Up to four LD CURV 500® satellites can be operated at each of the outputs
® ES Entertainer Set as a Mono Set, use the satellite output LEFT for the control
satellites left and right and the MONO / STEREO (26) switch on the mixer control panel must not
®
PES) requires the use of the satellite output LEFT (left) for the control of the LD CURV 500
®
16
17 22
23
18
24
19
25
26
20
AVS A/V Set, use both satellite
®
PS Power Set as a Stereo Set (or the
®
27
21
28
29
30
31
® satellite
7