SilverCrest HG04791 Instructions D'utilisation Et Consignes De Sécurité page 22

˜ Toggling between
weighing units
Press the U button 7 to toggle to
another weighing unit.
In normal weighing mode, you
can choose between grams (g),
pounds:ounces (lb:oz) and ounces
(oz).
You can choose between millilitres (ml),
fluid ounces (fl'oz) and cups (CUP) in
the modes for determining the volume.
NOTES:
If you select gram (g) in normal
weighing mode, fluid ounces (fl'oz)
cannot be displayed in volume mode.
If you select pounds:ounces (lb:oz) or
ounces (oz) in normal weighing mode,
millilitres (ml) cannot be displayed in
volume mode.
The volume of flour can only be
expressed in cups (CUP).
˜ Tare function/Reset
Briefly press the on/off switch /Z 5 .
The LC display 4 shows 4 horizontal
lines for a short moment. The value 0 is
then displayed.
If the foodstuff have been already
placed in the measuring jug 1 , the LC
display 4 will still read 0.
Place the item you wish to weigh in the
measuring jug 1 . The LC display 4
will show the weight of the item you are
weighing.
22 GB/IE
Pressing the on/off switch /Z 5
will change the LC display 4 from the
reading to "0". The letter T will appear
in the lower left corner of the LC display
4 .
To display the weight of the foodstuff
item again, briefly press the on/off
switch /Z 5 again. The letter T goes
off and the reading will change back to
the total weight of the foodstuff.
If you remove the foodstuff item after
using the tare function, a negative value
is displayed. Briefly press the on/off
switch /Z 5 to reset the scale to 0.
m
CAUTION! Do not – especially
when using the tare function – exceed
the maximum permitted weighing
value. Otherwise, the product may be
damaged.
˜ Changing the battery
Replace the battery as soon as " Lo " is
displayed or if the product cannot be
switched on anymore.
Loosen the screw of the battery
compartment cover 8 , using a
screwdriver.
Remove the battery compartment
cover 8 .
Remove the used button cell.
Insert a new CR2032 button cell. The
positive pole (+) must point outwards.
Replace the battery compartment
cover 8 .
Secure the battery compartment
cover 8 with the previously loosened
screw.