Install The Casters - Gladiator GAGB272DLG Instructions D'assemblage

2a.

Install the casters

Insert the carriage-head bolts (F1) into the keyhole slots and slide
the bolts into place as shown. Position the two rigid casters over
the bolts in the front cabinet location, with the brakes toward the
inside, and start four self-locking nuts for each caster. Hold the
casters in place, making sure the bolts are seated in the narrow
ends of the keyhole slots. Tighten the self-locking nuts (F4) with a
10 mm wrench. To attach the two swivel casters to the rear caster
location, repeat previous steps.
3.
Install the Convertible Tray or Drawers
Removing the Convertible Tray or Drawer:
Unload the contents from the convertible tray or drawer. Slide out
the convertible tray or drawer as far as it will go. Press the lever
down on the right-hand track and lift the lever up on the left track
to release the convertible tray or drawer.
Replacing the Convertible Tray or Drawer:
Align the convertible tray or drawer guides with the receiving
glides. Hold the receiving glides firmly and insert the convertible
tray or drawer guide.
NOTE: It is normal for the convertible tray or drawer to close
tightly the first time after it has been removed.
Push the convertible tray or drawer in completely.
4
Install the Casters
A
A. Lever
2b.
Install the casters
A. Front of cabinet
B. Rigid casters
Return the cabinet to its upright position. Replace the top mat
with the textured side facing up. Unlock the doors or drawers.
Place the liner(s) in the tray or the drawers.
A
B
C
D
C. Caster brakes
D. Swivel casters