Prior To Use; Thermostat - Gamko GB-Line Mode D'emploi

Chapter 3
•
Clean the cabinet prior to use. For further details we refer to chapter
maintenance.
• Leave the installation to stand for at least 2 hours before switching
on the cabinet.
• Plug into a grounded power socket.
GM-line plug ready models have an electronic thermostat.
Using the thermostat
For use and settings of the thermostat, please refer to the manual
supplied with this product.
XR02CX
To see the set point.
1. Push and immediately release the SET key, the set point will
be showed;
2. Push and immediately release the SET key or wait about 5 sec
to return to normal visualisation;
To change the set point.
1. Push the SET key for more than 3 sec, the value will be
displayed and the °C LED starts blinking;
2. To change the set point value push the arrows and to
memorise the new set point value push the SET key again or
wait 10sec.
User Manual
Using the appliance

Prior to use

EMERGENCY STOP
REMOVE THE PLUG FROM THE SOCKET!

Thermostat

81
77