Denon SYS-76HT Mode D'emploi page 13

(2) Connecting the speaker terminals – Speaker System (SC-A76, SC-C76)
Read the AV surround receiver's (or amplifier's) operating instructions carefully before connecting, and be sure to
use properly.
When connecting the equipment or changing the connections, be sure to turn the equipment's power switches
off and unplug the power plugs from the AC power outlets.
Connecting the speaker terminals
2
1. Peel off the sheath from the tip of the connection cord, then firmly twist the wires by hand so that they do not
stick out and cause short-circuits.
2. Press and lower the lever, and insert the cord's core wire into the hole.
3. Release the lever.
Gently pull on the connection cord to check that it is firmly connected.
Sheath
1
Black : "–" (negative)
Silver colored core wire
NOTE: Make sure the core wires do not touch each other.
Once the connections are completely, gently pull on the speaker cords to make sure they are securely
connected.
CAUTION:
• Be careful to interconnect the positive ("+", red) and negative ("–", black) sides
and the left and right speakers properly.
• Connect the side of the included connection cord with the copper colored core
wires to the red speaker terminal.
• To prevent circuit problems, never short-circuit copper and silver colored core wires
or the left and right cords.
When installing, carefully examine the place and method of installation for safety.
When using a stand, brackets, etc., follow the instructions included with the stand or brackets and check for
safety before installing and using. DENON will accept no responsibility for damages or accidents caused by the
unit falling.
2
Red : "+" (positive)
Copper colored core wire
7
ENGLISH
ENGLISH
3