Denon SYS-76HT Mode D'emploi page 12

ENGLISH
CONNECTIONS
CAUTION:
• Do not plug the power supply cord into an AC power outlet until all connections have been completed.
• Check the left and right channels and be sure to interconnect them properly, L (left) to L, R (right) to R.
• Plug the power supply cord in securely. An insecure connection could cause noise.
• Note that clamping pin-plug cords and power supply cords together or running pin-plug cords near the power
transformer could result in humming or noise.
• Check the polarities of the speakers and AV surround receiver (or amplifier) and be sure to interconnect
properly. Connect the red terminal on the speaker to the "+" speaker terminal on the AV surround receiver
(or amplifier), the black terminal on the speaker to the "–" speaker terminal on the AV surround receiver (or
amplifier).
(1) Connecting the line input connector (LINE IN) – Active subwoofer (DSW-76)
Connect this to the pre-out connector for the active subwoofer on the AV surround receiver (or amplifier)
("SUBWOOFER PREOUT", "MONO OUT", etc.) using the included connection cord (3-meter RCA pin-plug
cord).
CAUTION:
• If this connector is connected to the pre-out connector for the surround center channel of a stereo amplifier
or AV surround receiver (or amplifier), only the center channel's bass sound will be produced, so the overall
bass sound will be insufficient.
Included connection cord
(3-meter RCA pin-plug cord)
6
ENGLISH
Active subwoofer (DSW-76)