Battery Charger Safety - Husqvarna 120iTK4-H Manuel D'utilisation

1. Make sure that the power trigger is locked when the
lockout is in its initial position.
2. Pull and release the lockout and make sure that it
moves back to its initial position .
3. Make sure that the power trigger and the lockout
move freely and that the return spring operates
correctly.
4. Start the product, see
12 .
5. Apply full speed.
6. Release the power trigger and make sure that the
cutting attachment stops fully.
Battery safety
WARNING:
instructions that follow before you use the
product.
• The recommended battery is BLi10. Refer to
Technical data on page 16 . The battery is software
encrypted.
1553 - 005 - 06.04.2021
To start the product on page
Read the warning
• Use the BLi10 battery that is rechargable as a power
supply for the related Husqvarna products only. To
prevent injury, do not use the battery as a power
supply for other devices.
• Risk of electrical shock. Do not connect the battery
terminals to keys, coins, screws or other metal. This
can cause a short circuit of the battery.
• Do not use non-rechargeable batteries.
• Do not put objects into the air slots of the battery.
• Keep the battery away from sunlight, heat or open
flame. The battery can cause burns and/or chemical
burns.
• Keep the battery away from rain and wet conditions.
• Keep the battery away from microwaves and high
pressure.
• Do not try to disassemble or break the battery.
• If the battery leaks, do not let the liquid touch your
body or eyes. If you have touched the liquid, clean
the area with a large quantity of water and soap, and
get medical aid. If you get liquid in your eyes, do not
rub but flush with water for a minimum of 15 minutes
and get medical aid.
• Use the battery in temperatures between -10 °C (14
°F) and 40 °C (114 °F).
• Do not clean the battery or the battery charger with
water. Refer to To clean the product, the battery and
the battery charger on page 14 .
• Do not use a defective or damaged battery.
• Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
• Keep the battery away from children.

Battery charger safety

WARNING:
instructions that follow before you use the
product.
• Risk of electrical shock or short circuit if the safety
instructions are not obeyed.
• Do not use other battery chargers than the one
supplied for your product. The recommended
charger is QC80 when you charge the BLi10 battery.
• Do not try to disassemble the battery charger.
• Do not use a defective or damaged battery charger.
• Do not lift the battery charger by the power cord. To
disconnect the battery charger from a mains socket,
pull out the plug. Do not pull the power cord.
• Keep all cables and extension leads away from
water, oil and sharp edges. Make sure that the cable
is not caught between objects, for example, doors,
fences or equivalent.
• Do not use the battery charger near flammable
materials or materials that can cause corrosion.
Make sure that the battery charger is not covered.
Pull out the plug to the battery charger if there is
smoke or fire.
Read the warning
9