Ryobi CML-180 Manuel D'utilisation page 6

GB
FR DE ES
DESCRIPTION
1. Switch trigger
2. Lock-on button
3. Battery Pack Latches
4. Battery pack (not included)
5. Bezel
6. Lens seal
7. Lens
8. Reflector
9. Groove
10. Tabs
11. Ridge
12. Notches
13. Spade connection terminal
14. Connection point
15. Retainer clip
16. Red circuit lead
17. Bulb assembly
18. Fuse
OPERATION
TO INSTALL BATTERY PACK
See Figures 1 - 2.
Leave the switch trigger in the OFF position.
Q
Place the battery pack in the spotlight.
Q
Make sure the latches on each side of the battery
Q
pack snap in place and that battery pack is secured in
the spotlight before beginning operation.
TO REMOVE BATTERY PACK
See Figures 1 - 2.
Leave the switch trigger in the OFF position.
Q
Locate latches on side of battery pack and depress
Q
both sides to release battery pack.
Remove battery pack from the spotlight.
Q
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be in the OFF
position when not in use or carrying at your side.
SWITCH TRIGGER
See Figure 1.
To turn the spotlight ON, depress and hold the switch
trigger. To turn it OFF, release the switch trigger.
IT NL PT DK SE FI NO RU PL CZ
English
LOCK-ON BUTTON
See Figure 1.
The spotlight is equipped with a lock-on feature, which
is convenient for continuous use for extended periods
of time.
To lock-on:
Depress the switch trigger.
Q
Push in and hold the lock-on button, located on the
Q
side of the handle.
Release the switch trigger.
Q
Release the lock-on button.
Q
To release the lock, depress and release the switch
Q
trigger.
REPLACING BULBS
See Figures 3 - 5.
Over time, the bulb will burn out. When this occurs,
replacing the bulb will be necessary. Be careful not to
touch the bulb glass. This will reduce the life of the bulb.
To replace a bulb:
Remove battery from the spotlight and let it cool for at
Q
least 5 minutes.
Turn the bezel counterclockwise to remove.
Q
Remove the reflector assembly from the spotlight
Q
housing. Do not pull on the leads connected to the
assembly.
Remove the white connection point from its nest in
Q
the housing.
Remove the white connection terminal from its
Q
connection point.
NOTE: Do not pull white lead without holding the
connection point, as this may damage lead.
Remove the retainer pin from the reflector and
Q
remove bulb assembly.
NOTE: When purchasing replacement bulb, request
to RYOBI after-sales service for recommended part
number 019020001007. Always use bulb with same
characteristics and size.
REPLACEMENT FUSE
See Figure 6.
If the spotlight blows its fuse, you will need to replace it.
Look for replacement fuses where you purchased this
product.
Remove the battery pack from the spotlight to access
Q
fuse housing.
2
HU RO LV LT EE HR SI SK GR TR