Remote Control Code - Panasonic Technics Grand Class SU-G30 Manuel D'utilisation

01 [ ]: Standby/on switch
• Press to switch the unit from on to
standby mode or vice versa. In standby
mode, the unit is still consuming a small
amount of power.
02 [NET]/[DIGITAL]/[ANALOG]: Select the
device to be operated
( 24, 30, 31, 32, 33, 34, 35, 36)
03 [>INPUT<]: Switch the input source
04 [MENU]: Enter menu
( 24, 25, 28, 30, 32, 33)
05 [SETUP]: Enter setup menu ( 38)
06 [LAPC]: Measure the output signal of
the amplifier and correct its output
( 41)
07 [+VOL-]: Adjust the volume
• -- dB (min), -99.0 dB to 0 dB (max)
08 [MUTE]: Mute the sound
• Press [MUTE] again to cancel. "MUTE"
is also cancelled when you adjust the
volume or when you turn the unit to
standby.
09 Basic playback control buttons
10 [DIMMER]: Adjust the brightness of the
display, etc.
• When the display is turned off, it will
light up only when you operate this unit.
Before the display turns off again, "Display
Off" will be displayed for a few seconds.
• Press repeatedly to switch the brightness.
11 [INFO]: View content information
• Press this button to display the
track, artist, and album names, file
type, sampling frequency, and other
information. (The information varies
depending on the input source.)
12 [ ], [ ], [ ], [ ]/[OK]: Selection/OK
13 [RETURN]: Return to the previous
display
14 [DIRECT]: Turn on/off Direct mode
15 [RE-MASTER]: Turn on/off Re-master
16 Numeric buttons, etc.
• To select a 2-digit number
Example:
16: [ 10] > [1] > [6]
• To select a 4-digit number
Example:
1234: [ 10] > [ 10] > [ 10] > [1] > [2] > [3]
> [4]
• [CLEAR]: Clear the entered value.

Remote control code

When other equipment responds to the supplied
remote control, change the remote control code.
• The factory default is "Mode 1".
1 Press [SETUP].
2 Press [ ], [ ] to select "Remote
Control" and then press [OK].
• The current remote control code of this unit
is displayed.
3 When "Set Mode 1/2" is displayed, set
the remote control code of the remote
control.
To set "Mode 1":
Press and hold [OK] and [1] for at least 4
seconds.
To set "Mode 2":
Press and hold [OK] and [2] for at least 4
seconds.
4 Point the remote control at this unit,
and press and hold [OK] for at least 4
seconds.
• When the remote control code is changed,
the new code will appear on the display for a
few seconds.
■
When "Remote 1" or "Remote 2" is
displayed
When "Remote 1" or "Remote 2" is displayed,
the remote control codes of this unit and remote
control are different. Perform step 3 above.
Control reference guide
15
(15)